BANK sensor is a multifunctional sensor of the module that controls the looper\recorder(LR).
In combination with the ADD or DEL sensors — switches the LR banks.
Each of the four LR channels is also associated with one of the four banks of loops.
To switch bank: while holding BANK, press ADD or DEL of the desired channel.
The activated bank is indicated by a lit yellow LED to the left of the ADD sensor.
It is possible to partially or fully copy the contents of banks into each other. To do this, while the LR is playing, hold BANK and press ADD + DEL of the channel you want to copy to. The bank will switch over while copying the contents of the previous bank to the selected bank. Copying occurs on the fly, i.e. without stopping playback and does not interrupt the play process. Сopying will be performed only on those channels where the recording mode is turned on. Copying occurs exactly as long as the combination of three buttons is held. If you need to copy the entire loop, you must hold this combination for at least the length of the entire loop of the looper. You can also copy the loop partially, holding the combination only for the desired fragment. This allows you to mix fragments from different banks. When copying,
the previous contents of the bank are erased.
BANK + L (stop) — stops the LR.
BANK + M (start) + one of the ADD or DEL sensors — starts or restarts the LR from the
specified position. The LR loop is divided into 8 equal parts. Each part is associated with
one of the 8 ADD and DEL sensors. By pressing BANK + M and the desired sensor, you can
start the loop from that section. If LR is already running, it will restart from the specified
position. This allows for non-integer measures and changing rhythmic patterns.
BANK + L + M + one of the sensors (ADD or DEL) of the desired LR channel — will
quantize the content of the channel to 16 notes. The LR will stop when this operation is
performed. To start it again, use the start function. For the quantize function to work cor-
rectly, please make sure that the LR is aligned with the clock dividers!! To do this, press the
RST button on the CLOCK module before recording, and\or connect the LRST pin to the
0.25 output of the clock divider, and use a metronome during the recording!